More shameless copy and pasting from my Facebook page because it’s late and I can’t be arsed to rewrite everything. There are two posts cobbled together here so let’s get into it:

PART ONE

Anybody remember this chap?

I must have painted him a couple of years ago as part of my Bretonnian foot knight command but I never got around to painting the banner. I hate painting banners as I find it awkward in comparison to painting figures. Anyway, having decided to move onto getting some more fantasy stuff painted I thought I’d better try and finish this off and fill that empty slot in my unit.

Just base coats at the moment but thought I’d show how I’ve got a nice clean edge to the quarters. I use Scotch Magic Tape to mask the area. It’s easy to tear by hand and isn’t horribly sticky which means it’s great for masking. I made sure to press the tape down hard along the edge to be painted to avoid it bleeding under. Got to make sure the painted areas are good and dry though as they can still lift off when removing the tape. It makes the process quite slow going and only once did I have to retouch a small area that peeled after not following my own advice. Make sure the paint isn’t too watery to also help reduce the chance of it bleeding through but don’t apply it too thickly either or you’ll leave a ridge when the tape comes off.

I’ll shape the banner before I highlight it. It’s a piece of sheet metal (tomato puree tube) and the paint copes perfectly well with the flexing. Then I’ll have to print off some decals for the lions and go through all that rigmarole. This might all get done fairly quickly or it could take a while, I’ve no idea but I am going to get it finished this time.

PART TWO

I’m slowly progressing with my Bretonnian foot knight standard bearer. I needed a little decoration to pop on the end of the flag pole so I decided to replicate the fleur-de-lis that I used on another Bretonnian standard.

This is the green stuff press mould that I made a few years ago. The original part was cut from a 5th edition Bretonnian standard. I used a mix of green stuff and Milliput white in the mould. A little cooking oil stops the putty sticking.

Once dry pop it out of the mould and clean up the flash. It’s not a bad reproduction. If I’d used just Milliput I could have filed the edges a bit sharper but it’ll look fine once painted up.

There’s a quick snap of a little of the painting I’ve been doing on the flag too. Unfortunately the highlighting and shading that should give some added shape to the flag is completely washed out in the photo. But it’s evidence that I’ve not dumped it in favour of doing something easier again. Still need to work on the front of the flag before printing off some lion rampant decals.